Table of Contents
Advertisement
2.
Press } or † as needed to move the cursor to MODE and
press Í. A list of data collection modes appears.
3.
Press the number beside the mode you want.
Note: If you choose Time Graph mode, another screen appears allowing you to choose the
time interval between samples and the number of samples that you want. See Change Time
Graph Settings below for instructions.
4.
Press À OK twice to return to the Main Screen.
Change the Time Graph Settings (optional)
If you choose Time Graph on the Select Mode screen, the Time Graph Settings
screen appears. Each sensor has a default time interval between samples (in
seconds) and default number of samples (data points). To change the settings from
the default, follow the steps below:
If you press Á TIME GRAPH on the Select Mode screen, the
Time Graph Settings screen appears.
1.
Press Á CHANGE TIME SETTINGS.
2.
Key in the time interval between samples (in seconds)
and press Í.
3.
Key in the number of samples and press Í. The Time Graph Settings screen is
displayed again. (EXPERIMENT LENGTH in seconds is calculated automatically.)
4.
Press À OK to exit. The Setup screen appears.
or
Press  ADVANCED to change the advanced settings. (See Change the
Advanced Time Graph Settings for instructions.)
10
G
S
ETTING
TARTED WITH THE
CBL 2™ S
YSTEM
© 2000, 2003 T
I
EXAS
NSTRUMENTS
I
NCORPORATED
Advertisement
Table of Contents
