Table of Contents
Advertisement
Sensors that are not auto-ID can also be used with CBL 2™ by selecting the sensor
type from a list of sensors in DataMate.
Note: Technical specifications of TI sensors (including chemical tolerance) are provided in the
CBL 2 Technical Reference document available on the TI web site and the Resource CD.
Getting Started
Before you begin working with the CBL 2 system and the DataMate software, you
must connect the CBL 2 and your calculator and transfer the software from CBL 2 to
your calculator.
Put the Pieces Together
1.
Insert the upper end of the calculator into the cradle.
2.
Press down on the lower end of the calculator until it snaps in place.
3.
Slide the back of the cradle onto the front of the CBL 2 until it clicks in place.
4.
Plug one end of the 6-inch unit-to-unit link cable into the I/O port in the end of
the CBL 2, and plug the other end of the cable into the I/O port in the end of
the calculator.
The cradle cannot be used with the TI-92, TI-92 Plus, or Voyage™ 200 PLT.
Attach these calculators using a unit-to-unit cable.
Transfer DataMate to the Calculator
DataMate comes already loaded on your CBL 2. When transferring DataMate from
CBL 2 to the calculator, the CBL 2 automatically detects which calculator is attached
and transfers the appropriate version of DataMate.
4
G
S
ETTING
TARTED WITH THE
Figure 2. Connecting CBL 2 to a Calculator
CBL 2™ S
YSTEM
© 2000, 2003 T
I
EXAS
NSTRUMENTS
I
NCORPORATED
Advertisement
Table of Contents
