After working inside your system
Prerequisites
Follow the safety guidelines listed in
Steps
1. Replace the system cover.
2. If applicable, remove the I/O connector cover from the system connectors. Install the sled into the enclosure.
3. Reconnect the peripherals and connect the system to the electrical outlet, and then power on the system.
XR8000r chassis
Removing a sled blank
Prerequisites
Follow the safety guidelines listed in
Steps
Pull the sled blank to remove it from the enclosure.
Figure 15. Removing a sled blank
Next steps
Install a sled
or
sled
blank.
Safety
instructions.
Safety
instructions.
Installing and removing system components
49