Dell PowerEdge XR8610t Installation And Service Manual page 37

Table 34. Network Settings details (continued)
Option
NVMe-oF Host Id
Host Security Key Path
NVMe-oF SubSystem Settings
Table 35. PXE Device n Settings details
Option
Interface
Protocol
VLAN
VLAN ID
VLAN Priority
Table 36. HTTP Device n Settings details
Option
Interface
Protocol
VLAN
VLAN ID
VLAN Priority
DHCP
IP Address
Subnet Mask
Gateway
DNS info via DHCP
Primary DNS
Secondary DNS
URI (will obtain from DHCP
server if not specified)
TLS Authentication
Configuration
Description
Tag>. This is set to nqn.1988-11.com.dell:<model name>.<model
number>.<service tag> by default.
This field specifies a 16 bytes value of the NVMe-oF host identifier
that uniquely identifies this host with the controller in the NVM
subsystem. Allowed input is a hexadecimal-encoded string in this format:
00112233-4455-6677-8899-aabbccddeeff. Leave it empty to use system
generated value. A value of all FF is not allowed. This is set to
FFFFFFFF-FFFF-FFFF-FFFF-FFFFFFFFFFFF by default.
This field specifies the Host security key path.
This field controls the parameters for the NVMe-oF subsystem n
connections.
Description
Specifies NIC interface used for the PXE device.
Specifies Protocol used for PXE device. This option is set to IPv4 or IPv6. This option is set to
IPv4 by default.
Enables VLAN for PXE device. This option is set to Enabled or Disabled. This option is set to
Disabled by default.
Shows the VLAN ID for the PXE device
Shows the VLAN Priority for the PXE device.
Description
Specifies NIC interface used for the HTTP device.
Specifies Protocol used for HTTP device. This option is set to IPv4 or IPv6. This option is set
to IPv4 by default.
Enables VLAN for HTTP device. This option is set to Enable or Disable. This option is set to
Disable by default.
Shows the VLAN ID for the HTTP device
Shows the VLAN Priority for the HTTP device.
Enables or disables DHCP for this HTTP device. This option is set to Enable by default.
Specifies IP address for the HTTP device.
Specifies subnet mask for the HTTP device.
Specifies gateway for the HTTP device.
Enables or disables DNS Information from DHCP. This option is set to Enable by default.
Specifies the primary DNS server IP address for the HTTP Device.
Specifies the secondary DNS server IP address for the HTTP Device.
Obtain URI from the DHCP server if not specified
Specifies the option for TLS authentication configuration.
Pre-operating system management applications 37