Table of Contents
Advertisement
Symptom
-----------------------------------------------------------------------------------------------------------------------------------
The check engine
indicator does not
operate properly.
The check engine
indicator stays on
all of the time.
The clock doesn't
keep time.
Display is too dark.
Back up camera not Trigger not configured
displaying video
Display is blue when Camera is not powered on
in reverse
Using GPS, speed
reads 0
'NO DATA'
message
'NOT SUPPORTED' READING or GAUGE
message
'XXX OPEN'
message
'XXX SHORTED'
message
Possible Problem
The Control Box ENGINE terminal
is not connected to an EFI
control module.
The Engine Control Module
(ECM) needs to see the
load of a light connected to it.
Constant power terminal is
losing power.
Brightness needs to be adjusted.
Camera not plugged in
or video is not at Instrument
CLUSTER
No GPS data received
No satellites detected
BIM providing information
is not connected
BIM is non setup properly
Faulty BIM
selection not allowed
for the ARRANGEMENT
No connection to selected
sensor at control box
Broken or cut wire
Sensor wiring to control box
terminals
Pinched wire from sensor
Solution
This feature is designed to work
with engine control systems that
provide an active low signal.
Connect a light or similar load
to the ECM along with the
Control Box.
Ensure constant power terminal
has 12v even when key is off.
See manual for brightness adjusting
instructions.
Check setting in SETUP-CAMERA-TRIGGER
Check wiring to Control Box
Confirm trigger signal is valid
Check power at camera when in reverse
Make sure RCA connector is plugged in
to the rear of the Instrument Cluster
GPS receiver may still be trying to acquire
satellite, this may take 5-15 min,
Metal structure may be blocking signals, so
move vehicle outside, away from possible
interference objects
Check wiring and BIM connection
Refer to BIM manual for correct setup
Replace BIM
Change the ARRANGEMENT to one that
will support the desired READING or
GAUGE
Check connection for loose or no contact
Fix wire or replace sensor
Check connection for short
Fix wire or replace sensor
54
MAN# 650814
Advertisement
Table of Contents
