Table of Contents
Advertisement
INFO (Sensor, GPS, Version, Display)
The MAIN-SYSTEM-INFO sub-menu contains a collection of informational items for quick
reference, and there are no settable sub-menu items.
• From MAIN-SYSTEM menu list: LAYOUTS, DISPLAY, INFO, SWITCH, UPDATE, and BACK
displayed in menu box, rotate control knob until INFO is highlighted, tap to select
• SENSOR, GPS, VERSION, DISPLAY, and BACK will be displayed.
• Rotate the Control Knob to the desired selection, tap to select
SENSOR: List of all detected sensors connected to the Control Box, and the current settings that
are set in MAIN-SETUP, as well as the current reading if available.
GPS: If a satellite signal is detected, this is a list of associated parameters for that the signal.
VERSION: Contains a DISPLAY, CONTROL BOX, and BACK menu list can be selected to verify
the GRAFIX software that is installed. These release versions are beneficial to know when
checking if updates are available, or in case factory support is required.
• Rotate the Control Knob to DISPLAY, tap knob to select
o A list of the GRAFIX system's TFTs will be displayed: DISP1, DISP2, etc.
o As the knob is rotated through the list, the associated TFT on the Instrument Cluster
will be highlighted, as the other display intensities is reduced, tap knob to select
Note: If there is only one TFT in the GRAFIX system, only DISP1 will be
selectable.
o The associated software for the selected display will be listed:
o Theme 1- 4 version (version for each of the stored themes 1 - 4)
o Tap BACK to exit Display version
• Rotate the Control Knob to CONTROL BOX, tap to select
o The version of currently installed software will be displayed
o Tap the highlighted item or BACK to exit CONTROL BOX version
• Rotate to BACK, tap to exit VERSION
DISPLAY: Is a list of system items to assist in monitoring the GRAFIX operational status.
• TEMP (measured GRAFIX internal temp)
• SYSTEM (measured GRAFIX system current) (may not be present on some systems)
• DISP X (measured voltage on the GRAFIX module(s)
• Tap the highlighted item or BACK to exit
BACK: Exit VERSION and returns to MAIN-SYSTEM menu
SWITCH (Control Knob settings)
The MAIN-SYSTEM-SWITCH sub-menu is a list of settings for the Control Knob, specifically the
audible parameters.
• With MAIN-SYSTEM menu list: LAYOUTS, DISPLAY, INFO, SWITCH, UPDATE, and BACK
displayed in menu box, rotate control knob until SWITCH is highlighted, tap to select
• DURATION, VOLUME, TONE, SPD CNT VOL, and BACK be displayed.
• Rotate the Control Knob to the desired selection, tap to select
DURATION: Is the length of time a detected 'click' will be audible as the Control Knob is rotated.
This can be set in a range of 0 (no click) to 10 (longest available audible sound).
VOLUME: The audible sound level of the Control Knob 'click' heard while rotating. Available
range is 0 (off) – 10 (loudest available).
▪ Operational code version (DISP hardware)
▪ Configuration version (specific system setup)
34
MAN# 650814
Advertisement
Table of Contents
