Table of Contents
Advertisement
• Tap Control Knob to enter MAIN MENU
• Rotate knob to highlight SETUP, tap to select
• Rotate knob to WATER, tap to select
• A sub-menu list will appear: INPUT, UNIT, WARNING, and BACK
• Rotate the knob to the desired sub-menu item, tap to select
• INPUT: This allows selection between:
SENSOR: This is selected to set the supplied sensor as the temperature reading
source. Dakota Digital only offers one temp sensor, the SEN-04-5 which is capable
of reading 100-300 F (40-150 C). It has 1/8" NPT threads, and bushings can be
used to adapt the sensor to various locations. The following sub-menu choices are
also available:
BIM: Temperature can also be read with the use of a bus interface module (BIM).
The Dakota Digital BIM-01-X will allow you to read the engine temp signal from an
ECU if you are installing the GRAFIX system in a vehicle equipped with the OBDII
port or a drivetrain from a newer vehicle. Most 1996 and newer vehicles have this
OBDII port.
• UNIT: Choice of temp readings to be measured in Fahrenheit or Celsius. This selection
will be used for all temperature readings on the GRAFIX system.
• WARNING: This allows the selection of the high temperature warning point. When the
temperature reading's value is higher than this point, this will trigger the configured
GRAFIX Warning Systems. The warning value is adjustable from 150 – 300 F (65-148
C).
• BACK: Exit water setup and return to MAIN-SETUP sub-menu
OIL (Oil pressure setup)
The standard Dakota Digital oil pressure sensor for this system is the SEN-03-10, 0-150 psi solid
state sensor with 1/8" NPT threads. A 0-300 psi sensor (SEN-03-9) for higher pressure
applications, and a 0-100 psi sensor (SEN-03-8) are also supported. If "BIM" is selected for the
input type, the oil pressure reading should be coming into the BIM I/O port through the use of a
BIM module. The oil pressure setup allows you set up a low pressure warning point to trigger the
configured GRAFIX Warning Systems when the engine is running.
• Turn on ignition
• Tap Control Knob to enter MAIN MENU
• Rotate knob to highlight SETUP, tap to select
• Rotate knob to OIL, tap to select
• A sub-menu list will appear: INPUT, WARNING, and BACK
• Rotate the knob to the desired item, tap to select
• INPUT: This allows selection of the installed sensor or BIM as oil pressure source
SENSOR 100: Selects the supplied SEN-03-8 sensor
SENSOR 150: Selects the optional SEN-03-10 sensor
SENSOR 300: Selects the optional SEN-03-9 sensor
BIM: allows reading of the oil pressure from a BIM module in a compatible vehicle
• WARNING: This menu will allow you to select the low pressure warning point that will
trigger the configured GRAFIX Warning Systems. The value is adjustable from 5–36
psi.
• BACK: Exit oil setup and return to MAIN-SETUP sub-menu
DD: Will present the temperature from the SEN-04-5 as measured
DD CUSTOM: Allows the user to set an offset that will be added to the measured
temperature. This offset range is -20 to +20 F (-11 to +11 C).
42
MAN# 650814
Advertisement
Table of Contents
