Table of Contents
Advertisement
BACK
• Returns the user to MAIN-SYSTEM-LAYOUTS Layout # menu list
DISPLAY (Intensity, Turn remind, Gear, Set ODO, Extra Label, Start Image)
The MAIN-SYSTEM-DISPLAY sub-menu contains a collection of items to assist with and enhance
the GRAFIX visual presentation. Most of these are configured once at install, but can be edited
anytime depending on user preference or vehicle alterations.
• With MAIN-SYSTEM menu list: LAYOUTS, DISPLAY, INFO, SWITCH, UPDATE, and BACK
displayed in menu box, rotate control knob until DISPLAY is highlighted, tap to select
• INTENSITY, TURN REMIND, GEAR, SET ODOM, EXTRA LABEL, START IMAGE, and BACK
will be displayed.
INTENSITY
The brightness of the GRAFIX Instrument Cluster can be configured for each of the DAYTIME and
NIGHTTIME driving modes, as well as how the display will respond when in the MAIN-HI VIZ
(high visibility) mode. DAYTIME and NIGHTTIME can be set to the MANUAL mode giving the
user settings of 1-30 (1 = lowest brightness available, and 30 = highest). DAY and NIGHT can
also be set to AUTO mode similar to the HI VIZ mode. In the AUTO mode, ambient light is
monitored via a sensor on the Instrument Cluster. LOW, MED, and HIGH ambient light sensitivity
levels can be set in AUTO mode, and are based on the amount of ambient light detected before
an Instrument Cluster intensity change is initiated.
Note: If the GRAFIX is connected to a separately purchased DIM-1 kit from Dakota
Digital, the NIGHTTIME selection will be grayed out in this menu and not available to
edit. Instead, when the DIM terminal on the Control Box has power applied to it – i.e.
headlight switch is pulled on the DIM-1, the nighttime brightness level is controlled with
the twist of the DIM-1 knob.
Note: If the HI VIZ (high visibility) mode is 'ON' in the Main Menu, the intensity will go to
maximum level in DAYTIME operation regardless of the MANUAL INTENSITY setting.
TURN REMIND
If the turn indicators are wired to the GRAFIX Control Box, this setting allows a turn indicator to be
shown on the GRAFIX Instrument Cluster when the vehicle turn signal is 'engaged', and the
SHOW TRN IND is enabled. When enabled and the turn signal remains 'engaged' for more than
¾ mile, a warning message will be shown in the MESSAGE AREA. The user can also select
HIDE TURN IND, in which case the indicator will not be shown on the Instrument Cluster but the
warning still shows.
GEAR
If using a Dakota Digital GSS gear shift sender or a BIM-01-X connected to the Control Box is
receiving gear information from the ECM, the gear display will be active on the TFT display. You
can customize how the gears are displayed by selecting the appropriate gear order from the list
provided. The display will show the letter for the current gear in a large font in the center of the
gear window, with the other gears to either side in a smaller size.
SET ODOM
The Control Box will allow you to set the odometer miles to match your current odometer reading.
This can be done until you have driven 100 miles. Once you have driven more than 100 miles,
this menu option will be grayed out and no longer available. Make sure you have correctly
31
MAN# 650814
Advertisement
Table of Contents
