Demo Mode (Demonstration Mode Activation); Full Reset (Full Factory Reset) - Dakota Digital GRAFIX Installation And Operation Manual

Graphical display instrument system

Table of Contents

Note: If the configured camera trigger is 'triggered', but a valid video signal is not

detected on the Instrument Cluster camera input port, the GRAFIX display will go to

a solid blue raster.

DEMO MODE (Demonstration mode activation)

An exhibition or 'show' demonstration mode is available on the GRAFIX system. When activated

the GRAFIX Instrument Cluster will step through the saved DAY and NIGHT color setups of all 4

stored layouts. As it steps through the DAY and Night colors of each layout, it will also sweep all

analog gauges low to high then back, and also increase then decrease the digital readouts

simultaneously as required.

• By rotating the Control Knob counter clockwise during the Demo Mode execution, the user can

cycle through all 12 default color schemes as the sweep demonstration is occurring. By

rotating the knob clockwise, the user can cycle through the saved layouts.

• Tapping the Control Knob at any time will stop the Demo

MAIN-SETUP sub-menu, and the GRAFIX Instrument Cluster will return to the layout from

which the Demo mode was initiated.

If there is ever a situation where the GRAFIX system needs to get back to default factory settings,

this Full Reset will do just that. Maybe an engine or drivetrain swap? Maybe the GRAFIX system

is removed from one vehicle and installed in another? May the user just doesn't like what they

have done when setting it up? For whatever reason – Full Reset will return everything to the

default configuration settings that it had as it left the factory.

Knowing that the GRAFIX is a very configurable system with many user settings, and that it can

take considerable time to get setup...'just the right way', doing a factory reset can be quite

frustrating if it happens – but wasn't truly intended. This is why when the MAIN-SETUP-FULL

RESET is pressed, the user is asked if they want to reset – Yes or No. Then again if Yes is

selected, they are asked to confirm the reset – Yes or No. Then and only then, if a Yes is

selected, all the layouts, all the colors, Message Areas, warning parameters, etc. – are all returned

to factory defaults.

Note: Selecting NO or BACK in either of the reset confirmation sub-menus will return to

the user to MAIN-SETUP menu.

Note: Full Reset will not 'zero-out' the odometer miles. See SYSTEM-DISPLAY-SET

ODOM above for more details.

BACK (exit SETUP and return to MAIN MENU)

Mode,

the menu box will return to

MAN# 650814

Table of Contents