Table of Contents
Advertisement
• If you need the warn output to be "active high" or provide a +12V voltage to power something
larger than 4 Watt, a standard 12V relay such as Dakota Digital RLY-1 can be used to
accomplish this.
WARN OUT
• The WARN OUT terminal is an output to activate a small light or relay for a gauge warning
indicator. Alternatively, it can be used to activate reverse lights when using a GSS-3000 or
BIM-01 when in the REVERSE gear position. The output is ground-activated when any of the
activated gauge warnings are exceeded. This output can turn on a 4 Watt or smaller 12V bulb
or can activate a relay to turn on a larger bulb or buzzer. To wire a warning light to this output,
connect one wire from the bulb to 12 volt accessory power and connect the other wire to the
WARN OUT terminal.
• If you need the warn output to be "active high" or provide a +12V voltage to power something
larger than 4 Watt, a standard 12V relay can be used to accomplish this.
10
MAN# 650814
Advertisement
Table of Contents
