Table of Contents
Advertisement
L'exploitation est autorisée aux deux conditions suivantes : (1) l'ap-
pareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil
doit accepter tout brouillage radioélectrique subimême si le brouillage
est susceptible d'en compromettre le fonctionnement.
FCC/IC Label
This modular transmitter is labeled with its own FCC ID and IC num-
ber. When the module is installed inside the host device and the FCC
ID/IC of the module is not visible, the host device shall display the
provided label referring to the FCC ID and IC of the enclosed mod-
ule. This label is shipped together with the module and it is the respons-
ibility of the integrator to apply it to the exterior of the enclosure as
displayed in the following figure.
Label Placement
Bottom of the unit shows the label location
For UL/ULC Listed installation the products are intended to be
installed in accordance with the following:
A.
NFPA 70, "National Electrical Code."
B.
NFPA 72, "National Fire Alarm Code."
C.
UL 1641, "Installation and Classification of Residential Burglar
Alarm Systems."
D.
National Building Code (NBC);
E.
CSA C22.1 - Canadian Electrical Code, Part 1;
F.
CAN/ULC-S302 - Standard for Installation and Classification
of Burglar Alarm Systems for Financial and Commercial
Premises, Safes and Vaults;
G.
CAN/ULC-S540 - Standard for the Installation of Residential
Fire Warning Systems;
H.
CAN/ULC- S310 - Standard for the Installation and Clas-
sification of Residential Burglary Alarm Systems.
I.
CAN/ULC S301 - Standard for the Signal Receiving Centre
Burglar Alarm Systems and Operations
J.
Local Authorities Having Jurisdiction (AHJ).
K.
Manufacturer's Installation Instructions.
For UL Residential Fire and Burglary installations, the 3G8080 (I)
/CD8080(I) is listed as a sole means of communication or as a back up
when used in conjunction with a POTS line (dialer).
For UL Commercial Burglary installations, the 3G8080(I)/CD8080 (I)
is listed as a sole means of communication (supervision window of
200s required at monitoring station) or as a back-up when used in con-
junction with a POTS line (dialer).
The 3G4000 shall be powered from the compatible listed control unit
HS2128/HS2064/HS2032/HS2016 or compatible listed power supply
HSM2204/HSM2300 that complies with the ratings specified in this
manual.
For ULC Commercial Burglary installations the 3G8080 (I) /CD8080
(I) is listed as an active communication system with line security level
A1-A4 and as a passive communication system with communication
line security level P1 when used alone or as P2-P3 when used in con-
junction with the integrated POTS line (dialer) in the compatible NEO
Alarm Control panels HS2128, HS2064, HS2032, HS2016.
(actual size)
For ULC Residential Fire and Burglary installations the 3G8080 (I)
/CD8080(I) is listed as a sole means communication or as a back up
when used in conjunction with a POTS line (dialer).
For additional information about the modules discussed in this chapter,
refer to the Alarm.com web site.
- 26 -
Advertisement
Table of Contents
