Table of Contents
Advertisement
Installation
Follow these guidelines during installation.
Before affixing the communicator to a wall, verify the HSPA/CDMA signal level at the installation loc-
l
ation. On a keypad, press and hold the 5 key for 2 seconds to view the HSPA/CDMA signal level. An
installation location with a sustained signal level of two or more bars is recommended.
Do not exceed the panel total output power when using panel power for the 3G8080/CD8080 module, hard-
l
wired sensors, and /or sirens. Refer to the specific panel installation instructions for details. Only one
3G8080/CD8080 module can be used per panel.
To minimize potential interference with cellular signaling, avoid mounting the communicator in areas with
l
excessive metal or electrical wiring, such as furnaces or utility rooms.
Do not mount the 3G8080(I)/CD8080(I) communicator inside of the metal alarm panel enclosure.
Tools and Supplies Required
You will need the following tools and supplies:
Small flat-head and Phillips screwdrivers
l
Screws (included)
l
Antenna (included)
l
16 pin ribbon cable (included)
l
I
PCLINK_2
HS2016/2032/2064/2128
Alarm Controller Cabinet
NSTALLATION
A
B
C
- 10 -
HSPA/CDMA Controller
Advertisement
Table of Contents
