Table of Contents
Advertisement
CHOICE OF LAW - This Software License Agree-
ment is governed by the laws of the Province of
Ontario, Canada.
ARBITRATION - All disputes arising in connection
with this Agreement shall be determined by final and
binding arbitration in accordance with the Arbitration
Act, and the parties agree to be bound by the arbit-
rator's decision. The place of arbitration shall be
Toronto, Canada, and the language of the arbitration
shall be English.
LIMITED WARRANTY
NO WARRANTY -
DSC PROVIDES THE SOFTWARE "AS
IS" WITHOUT WARRANTY. DSC DOES NOT WARRANT
THAT THE SOFTWARE WILL MEET YOUR REQUIREMENTS
OR THAT OPERATION OF THE SOFTWARE WILL BE
UNINTERRUPTED OR ERROR-FREE.
CHANGES IN OPERATING ENVIRONMENT -
shall not be responsible for problems caused by changes in the oper-
ating characteristics of the HARDWARE, or for problems in the inter-
action of the SOFTWARE PRODUCT with non-DSC- SOFTWARE
or HARDWARE PRODUCTS.
LIMITATION
OF
REFLECTS ALLOCATION OF RISK -
IF ANY STATUTE IMPLIES WARRANTIES OR CONDITIONS
NOT STATED IN THIS LICENSE AGREEMENT, DSC'S
ENTIRE LIABILITY UNDER ANY PROVISION OF THIS
LICENSE AGREEMENT SHALL BE LIMITED TO THE
GREATER OF THE AMOUNT ACTUALLY PAID BY YOU TO
LICENSE THE SOFTWARE PRODUCT AND FIVE CANADIAN
DOLLARS (CAD$5.00). BECAUSE SOME JURISDICTIONS DO
NOT ALLOW THE
EXCLUSION OR LIMITATION
LIABILITY
FOR
CONSEQUENTIAL
DAMAGES, THE ABOVE LIMITATION MAY NOT APPLY TO
YOU.
DISCLAIMER OF WARRANTIES -
CONTAINS THE ENTIRE WARRANTY AND SHALL BE IN
LIEU OF ANY AND ALL OTHER WARRANTIES, WHETHER
EXPRESSED OR IMPLIED (INCLUDING ALL IMPLIED
WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A
PARTICULAR
PURPOSE)
OBLIGATIONS OR LIABILITIES ON THE PART OF DSC. DSC
MAKES NO OTHER WARRANTIES. DSC NEITHER ASSUMES
NOR AUTHORIZES ANY OTHER PERSON PURPORTING TO
ACT ON ITS BEHALF TO MOD8IFY OR TO CHANGE THIS
WARRANTY, NOR TO ASSUME FOR IT ANY OTHER
WARRANTY
OR
LIABILITY
SOFTWARE PRODUCT.
EXCLUSIVE
REMEDY
WARRANTY -
UNDER NO CIRCUMSTANCES SHALL DSC
BE
LIABLE
FOR
CONSEQUENTIAL OR INDIRECT DAMAGES BASED UPON
BREACH OF WARRANTY,
NEGLIGENCE, STRICT LIABILITY, OR ANY OTHER LEGAL
THEORY. SUCH DAMAGES INCLUDE, BUT ARE NOT
LIMITED TO, LOSS OF PROFITS, LOSS OF THE SOFTWARE
PRODUCT OR ANY ASSOCIATED EQUIPMENT, COST OF
LIABILITY;
WARRANTY
IN ANY EVENT,
OR
INCIDENTAL
THIS WARRANTY
AND
OF
ALL
CONCERNING
AND
LIMITATION
ANY
SPECIAL,
INCIDENTAL,
BREACH OF
CONTRACT,
CAPITAL, COST OF SUBSTITUTE OR REPLACEMENT
EQUIPMENT, FACILITIES OR SERVICES, DOWN TIME,
PURCHASERS TIME, THE CLAIMS OF THIRD PARTIES,
INCLUDING CUSTOMERS, AND INJURY TO PROPERTY.
DSC recommends that the entire system be completely tested on a reg-
ular basis. However, despite frequent testing, and due to, but not lim-
ited to, criminal tampering or electrical disruption, it is possible for this
SOFTWARE PRODUCT to fail to perform as expected.
Regulatory Information
For UL/ULC applications, the temperature rating is 0- 49° C and the
maximum relative humidity rating is 85% RH.
FCC Statement
Changes or modifications not expressly approved by DSC can void the
user's authority to operate the equipment. This equipment has been
tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a res-
idential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance
DSC
with the instructions, may cause harmful interference to radio com-
munications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment in to an outlet on a circuit different from that
which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC and Industry standards RF radi-
ation exposure limits set forth for an uncontrolled environment. This
OF
equipment should be installed and operated with a minimum distance of
20 centimeters between the radiator and your body.
Industry Canada Statement
CAN ICES-3(B)/NMB-3(B)
Under Industry Canada regulations, this radio transmitter only operates
using an antenna of a type and maximum (or lesser) gain approved for
the transmitter by Industry Canada. To reduce potential radio inter-
ference to others, the antenna type and its gain should be so chosen
OTHER
that the equivalent isotropically radiated power (e.i.r.p.) is not more
than that necessary for successful communication.
Conformément à la réglementation d'Industrie Canada, le présent
émetteur radio peut fonctionner avec une antenne d'un type et d'un
gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie
THIS
Canada. Dans le but de réduire les risques de brouillage radi-
oélectrique à l'intention des autres utilisateurs, il faut choisir le type
d'antenne et son gain de sorte que la puissance isotrope rayonnée équi-
OF
valente (p.i.r.e.) ne dépasse pas l'intensité nécessaire à l'établissement
d'une communication satisfaisante.
This device complies with Industry Canada licence-exempt RSS stand-
ard(s). Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must accept
any interference, including interference that may cause undesired
operation of the device. Le présent appareil est conforme aux CNR
d'Industrie Canada applicables aux appareils radio exempts de licence.
- 25 -
Advertisement
Table of Contents
