Table of Contents
Advertisement
Interactive Menus
The "Interactive Services" menu can be used to access information about the HSPA/CDMA module, install or
remove Z-Wave devices and configure or troubleshoot other interactive features.
To enter the menu, press [*] [8] [Installer Code] [851].
The menu will time out after 20 minutes. Refer to the following tables for the menu options.
Installer Programming
Press [*][8] [Installer Code] [851] to enter Interactive Services menu.
Menu
--HSPA/CDMA Module
Status
---Radio
---HSPA/CDMA Freq.
---SN
---SIM Card
---Version
---Advanced - Network
2
--Z-Wave Setup
--Number of Z-Wave
2
Devices
2
--Add Z-Wave Device
---Remove Z-Wave Device
2
---Z-Wave Home ID
---Image Sensor Setup
---Learn Image Sensor1
---Delete Image Sensor
---Image Sensor Settings
1
----Image Sensor #[x]
-----[Power Information]
I
NTERACTIVE
Scroll down through the various HSPA/CDMA module information screens
Signal level, connection status, roaming status, and errors (if any)
HSPA/CDMA frequency used by the module
Module serial number. Needed to create or troubleshoot an Alarm.com account
SIM card number. Sometimes needed to troubleshoot an account. Not applicable to
CDMA radios
HSPA/CDMA module firmware version and sub-version. Example: 181a; 181 =
module firmware version, a = subversion
Use only when instructed by Alarm.com Technical Support.
This menu is used to add, remove, and troubleshoot Z-Wave devices and
networks. To control Z-Wave devices via the Alarm.com website and smart phone
apps, you will also need to enable Z-Wave services on the account
The total number of Z-Wave devices currently known to the module
Press [*] to enter Z-Wave Add Mode. Make sure the device being added is powered
up and within 3 to 6 feet of the panel. Refer to the manufacturer's instructions for
button presses required to enroll devices
Press [*] to remove an existing Z-Wave device, or to "reset" a Z-Wave device that
2
was previously learned into a different Z-Wave network. Previously enrolled
devices must be reset before they can be enrolled into the module
Press [*] to query the Z-Wave network Home ID. If the ID is 0, verify that the
module has communicated with Alarm.com and that the Alarm.com account is set
up for Z-Wave.
An image sensor daughterboard is required to enable image sensor capabilities on
1
the module. This menu is only active if an image sensor daughterboard is
connected
Press [*] to enter Add Mode. Enroll the image sensor by inserting batteries or
resetting
1
Press [*] and scroll to the image sensor to delete. Press [*] to delete
1
Press [*] and scroll to the image sensor of interest. Press [*]
[x] is the sensor ID. Press [*] to view information on this image sensor
1
Gives information on the image sensor's battery level and power status
S
M
ERVICE
Description
- 21 -
Interactive Service Menu
ENU
Advertisement
Table of Contents
