Table of Contents
Advertisement
DRIVEABILITY - DIESEL
P1270-INTAKE PORT SWIRL ACTUATOR SHORT CIRCUIT —
TEST
3
Turn the ignition off.
Install a substitute Swirl Solenoid.
Turn the ignition on.
With the DRB, erase ECM DTCs.
With the DRBIII , actuate the Swirl Solenoid.
With the DRBIII , read the ECM DTCs.
Does the DRB display this DTC?
Yes → Replace and program the Engine Control Module in accordance
→ Replace the Swirl Solenoid.
No
4
WARNING: WHEN THE ENGINE IS OPERATING, DO NOT STAND IN A
DIRECT LINE WITH THE FAN. DO NOT PUT YOUR HANDS NEAR THE
PULLEYS, BELTS OR FAN. DO NOT WEAR LOOSE CLOTHING.
NOTE: The conditions that set the DTC are not present at this time. The
following list may help in identifying the intermittent condition.
With the engine running at normal operating temperature, monitor the DRB
parameters related to the DTC while wiggling the wiring harness. Look for param-
eter values to change and/or a DTC to set.
Review the DTC When Monitored and Set Conditions. If possible, try to duplicate the
conditions under which the DTC was set.
Refer to any Technical Service Bulletins (TSB) that may apply.
Visually inspect the related wiring harness. Look for any chafed, pierced, pinched, or
partially broken wires.
Visually inspect the related wiring harness connectors. Look for broken, bent, pushed
out, or corroded terminals.
Were any of the above conditions present?
Yes → Repair as necessary.
→ Test Complete.
No
ACTION
with the Service Information.
Perform ROAD TEST VERIFICATION - VER-2.
Perform ROAD TEST VERIFICATION - VER-2.
Perform ROAD TEST VERIFICATION - VER-2.
180
Continued
APPLICABILITY
All
All
Advertisement
Table of Contents
