Table of Contents
Advertisement
DRIVEABILITY - DIESEL
Symptom:
P0645-A/C CLUTCH RELAY CIRCUIT SHORT CIRCUIT
When Monitored and Set Condition:
P0645-A/C CLUTCH RELAY CIRCUIT SHORT CIRCUIT
When Monitored: With the ignition off.
Set Condition: The ECM detects excessive current on the A/C Clutch Relay Control
circuit.
INTERMITTENT CONDITION
A/C CLUTCH RELAY
A/C CLUTCH RELAY CONTROL CIRCUIT SHORTED TO VOLTAGE
ECM
TEST
1
Turn the ignition on.
With the DRBIII , actuate the A/C Clutch Relay.
Is the A/C Clutch Relay operating?
Yes → Go To 2
→ Go To 3
No
2
WARNING: WHEN THE ENGINE IS OPERATING, DO NOT STAND IN A
DIRECT LINE WITH THE FAN. DO NOT PUT YOUR HANDS NEAR THE
PULLEYS, BELTS OR FAN. DO NOT WEAR LOOSE CLOTHING.
NOTE: The conditions that set the DTC are not present at this time. The
following list may help in identifying the intermittent condition.
With the engine running at normal operating temperature, monitor the DRB
parameters related to the DTC while wiggling the wiring harness. Look for param-
eter values to change and/or a DTC to set.
Review the DTC When Monitored and Set Conditions. If possible, try to duplicate the
conditions under which the DTC was set.
Refer to any Technical Service Bulletins (TSB) that may apply.
Visually inspect the related wiring harness. Look for any chafed, pierced, pinched, or
partially broken wires.
Visually inspect the related wiring harness connectors. Look for broken, bent, pushed
out, or corroded terminals.
Were any of the above conditions present?
Yes → Repair as necessary.
→ Test Complete.
No
POSSIBLE CAUSES
ACTION
Perform ROAD TEST VERIFICATION - VER-2.
142
APPLICABILITY
All
All
Advertisement
Table of Contents
