DaimlerChrysler Jeep Grand Cherokee 2002 Service Manual page 119

Table of Contents

Advertisement

P0520-OIL PRESS SENSOR CKT MALF SUPPLY VOLTAGE TOO HIGH OR
LOW —
Continued
TEST
3
Turn the ignition off.
Disconnect the ECM harness connectors.
Disconnect the Oil Pressure Sensor harness connector.
Measure the resistance between ground and the 5-volt Supply circuit at the Oil
Pressure Sensor harness connector.
Is the resistance above 1000 ohms?
Yes → Go To 4
→ Repair the 5-volt Supply circuit for a short to ground.
No
4
Turn the ignition off.
Disconnect the ECM harness connectors.
Disconnect the Oil Pressure Sensor harness connector.
Measure the resistance between Sensor Ground and the 5-volt Supply circuit at the
Oil Pressure Sensor harness connector.
Is the resistance above 1000 ohms?
Yes → Replace and program the Engine Control Module in accordance
→ Repair the 5-volt Supply circuit for a short to Sensor Ground.
No
5
WARNING: WHEN THE ENGINE IS OPERATING, DO NOT STAND IN A
DIRECT LINE WITH THE FAN. DO NOT PUT YOUR HANDS NEAR THE
PULLEYS, BELTS OR FAN. DO NOT WEAR LOOSE CLOTHING.
NOTE: The conditions that set the DTC are not present at this time. The
following list may help in identifying the intermittent condition.
With the engine running at normal operating temperature, monitor the DRB
parameters related to the DTC while wiggling the wiring harness. Look for param-
eter values to change and/or a DTC to set.
Review the DTC When Monitored and Set Conditions. If possible, try to duplicate the
conditions under which the DTC was set.
Refer to any Technical Service Bulletins (TSB) that may apply.
Visually inspect the related wiring harness. Look for any chafed, pierced, pinched, or
partially broken wires.
Visually inspect the related wiring harness connectors. Look for broken, bent, pushed
out, or corroded terminals.
Were any of the above conditions present?
Yes → Repair as necessary.
→ Test Complete.
No
ACTION
Perform ROAD TEST VERIFICATION - VER-2.
with the Service Information.
Perform ROAD TEST VERIFICATION - VER-2.
Perform ROAD TEST VERIFICATION - VER-2.
Perform ROAD TEST VERIFICATION - VER-2.
DRIVEABILITY - DIESEL
111
APPLICABILITY
All
All
All

Advertisement

Table of Contents
loading

Table of Contents