DaimlerChrysler Jeep Grand Cherokee 2002 Service Manual page 151

P0645-A/C CLUTCH RELAY CIRCUIT SHORT CIRCUIT —
TEST
3 Turn the ignition off.
Remove the A/C Clutch Relay from the PDC.
Turn the ignition on.
Using a 12-volt test light connected to 12-volts, probe the A/C Clutch Relay Control
circuit in the PDC.
With the DRBIII , actuate the A/C Clutch Relay.
Does the test light cycle on and off?
Yes → Replace the A/C Clutch Relay.
→ Go To 4
No
4 Turn the ignition off.
Remove the A/C Clutch Relay from the PDC.
Disconnect the ECM harness connector.
Remove the ASD Relay from the PDC.
Connect a jumper wire between cavity 30 and cavity 87 of the ASD Relay connector.
Turn the ignition on.
Measure the voltage of the A/C Clutch Relay Control circuit.
Is the voltage above 1.0 volt?
Yes → Repair the A/C Clutch Relay Control circuit for a short to voltage.
→ Go To 5
No
5 If there are no possible causes remaining, view repair.
Repair
ACTION
Perform ROAD TEST VERIFICATION - VER-2.
Perform ROAD TEST VERIFICATION - VER-2.
Replace and program the Engine Control Module in accordance
with the Service Information.
Perform ROAD TEST VERIFICATION - VER-2.
DRIVEABILITY - DIESEL
143
Continued
APPLICABILITY
All
All
All