Table of Contents
Advertisement
DRIVEABILITY - DIESEL
P0651-SENSOR REFERENCE VOLTAGE B CKT VOLTAGE TOO LOW —
Continued
TEST
5
Turn the ignition off.
Disconnect the ECM harness connectors.
Disconnect the Accelerator Pedal Position Sensor harness connector.
Measure the resistance between ground and the Accelerator Pedal Position Sensor
5-Volt Supply circuit.
Is the resistance above 100 kohms?
Yes → Go To 6
→ Repair the Accelerator Pedal Position Sensor 5-Volt Supply circuit
No
6
Turn the ignition off.
Disconnect the ECM harness connectors.
Disconnect the Accelerator Pedal Position Sensor harness connector.
Measure the resistance between the Accelerator Pedal Position Sensor 5-Volt Supply
circuit and both Sensor Ground circuits.
Is the resistance above 100 kohms for each measurement?
Yes → Go To 7
→ Repair the Accelerator Pedal Position Sensor 5-Volt Supply circuit
No
7
If there are no possible causes remaining, view repair.
Repair
8
WARNING: WHEN THE ENGINE IS OPERATING, DO NOT STAND IN A
DIRECT LINE WITH THE FAN. DO NOT PUT YOUR HANDS NEAR THE
PULLEYS, BELTS OR FAN. DO NOT WEAR LOOSE CLOTHING.
NOTE: The conditions that set the DTC are not present at this time. The
following list may help in identifying the intermittent condition.
With the engine running at normal operating temperature, monitor the DRB
parameters related to the DTC while wiggling the wiring harness. Look for param-
eter values to change and/or a DTC to set.
Review the DTC When Monitored and Set Conditions. If possible, try to duplicate the
conditions under which the DTC was set.
Refer to any Technical Service Bulletins (TSB) that may apply.
Visually inspect the related wiring harness. Look for any chafed, pierced, pinched, or
partially broken wires.
Visually inspect the related wiring harness connectors. Look for broken, bent, pushed
out, or corroded terminals.
Were any of the above conditions present?
Yes → Repair as necessary.
→ Test Complete.
No
ACTION
for a short to ground.
Perform ROAD TEST VERIFICATION - VER-2.
for a short to the Sensor Ground circuit.
Perform ROAD TEST VERIFICATION - VER-2.
Replace and program the Engine Control Module in accordance
with the Service Information.
Perform ROAD TEST VERIFICATION - VER-2.
Perform ROAD TEST VERIFICATION - VER-2.
148
APPLICABILITY
All
All
All
All
Advertisement
Table of Contents
