Table of Contents
Advertisement
DRIVEABILITY - DIESEL
P0685-ASD RELAY CONTROL CIRCUIT SHUTS OFF TOO LATE —
Continued
TEST
3
Turn the ignition off.
Install a substitute relay in place of the ASD Relay.
Perform several ignition key cycles, pausing for at least 10 seconds between each
cycle.
Turn the ignition on.
With the DRB, read ECM DTCs.
Did this DTC set again?
Yes → Go To 4
→ Replace the ASD Relay.
No
4
Turn the ignition off.
Remove the ASD Relay from the PDC.
Disconnect the ECM harness connectors.
Measure the resistance between ground and the ASD Relay Control circuit while
wiggling the wiring harness and connectors.
Was the resistance below 5.0 ohms at any time while wiggling the wiring harness and
connectors?
Yes → Repair the ASD Relay Control circuit for an intermittent short to
→ Go To 5
No
5
Turn the ignition off.
Remove the ASD Relay from the PDC.
Turn the ignition on.
Measure the voltage of the ASD Relay Output circuit.
Is the voltage below 0.5 volt?
Yes → Replace and program the Engine Control Module in accordance
→ Repair the ASD Relay Output circuit for a short to voltage.
No
6
WARNING: WHEN THE ENGINE IS OPERATING, DO NOT STAND IN A
DIRECT LINE WITH THE FAN. DO NOT PUT YOUR HANDS NEAR THE
PULLEYS, BELTS OR FAN. DO NOT WEAR LOOSE CLOTHING.
NOTE: The conditions that set the DTC are not present at this time. The
following list may help in identifying the intermittent condition.
With the engine running at normal operating temperature, monitor the DRB
parameters related to the DTC while wiggling the wiring harness. Look for param-
eter values to change and/or a DTC to set.
Review the DTC When Monitored and Set Conditions. If possible, try to duplicate the
conditions under which the DTC was set.
Refer to any Technical Service Bulletins (TSB) that may apply.
Visually inspect the related wiring harness. Look for any chafed, pierced, pinched, or
partially broken wires.
Visually inspect the related wiring harness connectors. Look for broken, bent, pushed
out, or corroded terminals.
Were any of the above conditions present?
Yes → Repair as necessary.
→ Test Complete.
No
ACTION
Perform ROAD TEST VERIFICATION - VER-2.
ground.
Perform ROAD TEST VERIFICATION - VER-2.
with the Service Information.
Perform ROAD TEST VERIFICATION - VER-2.
Perform ROAD TEST VERIFICATION - VER-2.
Perform ROAD TEST VERIFICATION - VER-2.
152
APPLICABILITY
All
All
All
All
Advertisement
Table of Contents
