Cisco Catalyst 9500 Manual page 149

System management configuration guide, cisco ios xe amsterdam 17.2.x
Hide thumbs Also See for Catalyst 9500:
Table of Contents

Advertisement

Configuring Application Visibility and Control in a Wired Network
Step 10
Step 11
Step 12
Step 13
Step 14
Command or Action
match connection server transport port
Example:
Device(config-flow-record)# match
connection server transport port
match flow observation point
Example:
Device(config-flow-record)# match flow
observation point
collect flow direction
Example:
Device(config-flow-record)# collect flow
direction
collect connection initiator
Example:
Device(config-flow-record)# collect
connection initiator
collect connection new-connections
Example:
Device(config-flow-record)# collect
connection new-connections
System Management Configuration Guide, Cisco IOS XE Amsterdam 17.2.x (Catalyst 9500 Switches)
Flow Record 2 - Bidirectional Flow Record
Purpose
Specifies a match to the transport port of the
server.
Specifies a match to the observation point ID
for flow observation metrics.
Specifies to collect the direction — Ingress or
Egress — of the relevant side — Initiator or
Responder — of the bi-directional flow that is
specified by the initiator keyword in the
collect connection initiator command in the
step below. Depending on the value specified
by the initiator keyword, the flow direction
keyword takes the following values :
• 0x01 = Ingress Flow
• 0x02 = Egress Flow
When the initiator keyword is set to initiator,
the flow direction is specified from the initiator
side of the flow. When the initiator keyword
is set to responder, the flow direction is
specified from the responder side of the flow.
For wired AVC, the initiator keyword is
always set to initiator.
Specifies to collect the side of the flow —
Initiator or Responder — relevant to the
direction of the flow specified by the collect
flow direction command. The initiator
keyword provides the following information
about the direction of the flow :
• 0x01 = Initiator - the flow source is the
initiator of the connection
For wired AVC, the initiator keyword is
always set to initiator.
Specifies to collect the number of connection
initiations observed.
133

Advertisement

Table of Contents
loading

Table of Contents