Cisco Catalyst 9500 Manual page 276

Performing a Configuration Replace or Configuration Rollback Operation
Step 3
Step 4
Step 5
System Management Configuration Guide, Cisco IOS XE Amsterdam 17.2.x (Catalyst 9500 Switches)
260
Command or Action
configure revert { now | timer {minutes | idle
minutes} }
Example:
Device# configure revert now
configure confirm
Example:
Device# configure confirm
exit
Example:
Device# exit
Configuration Replace and Configuration Rollback
Purpose
• The revert trigger keywords set the
following triggers for reverting to the
original configuration:
• error —Reverts to the original
configuration upon error.
• timer minutes —Reverts to the
original configuration if specified
time elapses.
• The ignore case keyword allows the
configuration to ignore the case of the
confirmation command.
(Optional) To cancel the timed rollback and
trigger the rollback immediately, or to reset
parameters for the timed rollback, use the
configure revertcommand in privileged EXEC
mode.
• now —Triggers the rollback immediately.
• timer —Resets the configuration revert
timer.
• Use the minutes argument with the
timer keyword to specify a new
revert time in minutes.
• Use the idle keyword along with a
time in minutes to set the maximum
allowable time period of no activity
before reverting to the saved
configuration.
(Optional) Confirms replacement of the current
running configuration file with a saved Cisco
IOS configuration file.
Note Use this command only if the time
seconds keyword and argument
of the configure replace
command are specified.
Exits to user EXEC mode.