Configuring Online Diagnostics; Scheduling Online Diagnostics - Cisco Catalyst 9500 Manual

Configuring Online Diagnostics

Configuring Online Diagnostics
You must configure the failure threshold and the interval between tests before enabling diagnostic monitoring.

Scheduling Online Diagnostics

You can schedule online diagnostics to run at a designated time of day, or on a daily, weekly, or monthly
basis for a device. Use the no form of the diagnostic schedule switch command to remove the scheduling.
Procedure
Step 1
Step 2
System Management Configuration Guide, Cisco IOS XE Amsterdam 17.2.x (Catalyst 9500 Switches)
200
Command or Action
Command or Action
configure terminal
Example:
Device #configure terminal
diagnostic schedule switch number test {name
| test-id | test-id-range | all | basic | complete |
minimal | non-disruptive | per-port} {daily |
on mm dd yyyy hh:mm | port inter-port-number
port-number-list | weekly day-of-week hh:mm}
Example:
Device(config)# diagnostic schedule
switch 3 test 1-5 on July 3 2013 23:10
Configuring Online Diagnostics
Purpose
• basic: Starts the basic test suite.
• complete: Starts the complete test suite.
• minimal: Starts the minimal bootup test
suite.
• non-disruptive: Starts the nondisruptive
test suite.
• per-port: Starts the per-port test suite.
Purpose
Enters global configuration mode.
Schedules on-demand diagnostic test for a
specific day and time.
The switch number keyword is supported only
on stacking switches.
When specifying the test to be scheduled, use
these options:
• name: Name of the test that appears in the
show diagnostic content command output.
• test-id: ID number of the test that appears
in the show diagnostic content command
output.
• test-id-range: ID numbers of the tests that
appear in the show diagnostic content
command output.
• all: All test IDs.