Table of Contents
Advertisement
Open the front cover and verify that the strip length is 5.5mm. (0.22in.)
Wiring Inspection
After completing wiring, check the following :
▫ Wiring is proper.
▫ Wire clippings or screws are not left in the unit.
▫ Screws are securely tightened.
▫ Bare wire in the terminal does not contact other terminals.
NOTE
If the FWD (REV) run command is given during the operation reference
selection (n02=1) from the control circuit terminal, the motor will start
automatically after the main circuit input power supply is turned ON.
26
Advertisement
Table of Contents
