Table of Contents
Advertisement
2. Slide the edge guide all the way to the left, and facing the back of the printer, slide both
sprocket units all the way to the right.
3. Position the roll paper holder beneath the printer as shown below. Fit the two holes in the roll
paper holder base under the two positioning pegs on the bottom of the printer.
Gently lower the printer so the positioning pegs slide into the holes.
Caution:
!
The roll paper holder is not fastened to the printer; only the printer's weight and the two
positioning pegs hold it in place. If you pick up the printer, be careful not to drop the roll
paper holder.
Loading roll paper
Follow these steps to load a roll of paper after you install the roll paper holder:
1. Make sure the printer is turned off. Also make sure the paper tension unit is installed.
2. Set the paper release lever to the single-sheet position. Also set the paper-thickness lever
(located under the printer cover) to the proper position for your paper's thickness. See
"Adjusting the Paper-thickness lever" on page 31 for instructions.
LQ-690II/LQ-690IIN
User's Guide
Options and Consumables
107
Advertisement
Table of Contents
