15.3
Removing the rear wheel
–
Position both brake calipers.
The brake linings are correctly positioned.
–
Mount screws
Guideline
Screw, front
brake caliper
–
Operate the hand brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point. Secure the hand brake lever in the activated position.
The brake calipers straighten.
–
Tighten screws
Guideline
Screw, front
brake caliper
–
Position wheel speed sensor
–
Mount and tighten screw
Guideline
F02070-10
Screw, front wheel
speed sensor
–
Remove the locking piece of the hand brake lever.
–
Take the motorcycle off the front lifting gear. (
–
Remove the rear of the motorcycle from the lifting gear.
(
p. 81)
–
Operate the front brake and compress the fork a few times
firmly.
The fork legs straighten.
–
Tighten screws
Guideline
Screw, fork stub
F02067-11
Preparatory work
–
Raise motorcycle with rear lifting gear. (
5
on both sides but do not tighten yet.
M10x1.25
45 Nm (33.2 lbf ft)
5
on both sides.
M10x1.25
45 Nm (33.2 lbf ft)
6
in the hole.
7
.
M6
10 Nm (7.4 lbf ft)
8
.
M8
15 Nm (11.1 lbf ft)
WHEELS, TIRES 15
Loctite
®
243™
Loctite
®
243™
p. 82)
p. 81)
111