Sharp MX-B402 Operation Manual page 188

• System Settings (Administrator): Default original size setting
Set this if you frequently use a particular original size. The set size will appear in the [Original] key.
When this setting is configured, changing the original size can be omitted.
• System settings (Administrator): Setting of Default Original Exit Place (MX-B402SC Only)
When the automatic document feeder is used, the original's default output destination can be set to the upper exit or the
heavy exit. (Except when "Size Input" or "Card Size" is selected for the original size.)
MX-B402SC Only
• In the situations below, the original exit place is fixed to the heavy exit.
- When "Card Size" is selected
- When the original guide is set to 2 7/8" (74 mm) or lower (Except when "Check Size" is selected)
- When the automatic document feeder is scanning an original with an X (horizontal) value of 4 1/8" (105 mm) or less
• When "Card Size" is selected, you cannot copy if the original guide is set to 2 7/8" (74 mm) or higher.
Specifying a non-standard original size
Original
5½x8½ 8½x14
1
8½x11 8½x13
8½x13
Size Input
OK
AB
2
5
Inch
Custom Size None
Touch the [Size Input] key.
2-30
COPIER
Contents