Removing The Battery; Installing The Battery - KTM 250 EXC E-Starter EU 2010 Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

Removing the battery

x
11.68
Warning
Risk of injury Battery acid and battery gases cause serious cauterization.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep the battery away from sparks or open fire. Charge only in well ventilated rooms.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a doctor.

Installing the battery

x
11.69
–
Mount the desired auxiliary spring
the clutch cover together.
Auxiliary spring with yellow marking (54837072300)
Auxiliary spring with green marking (54837072100)
Auxiliary spring with red marking (54837072000)
The cut-out of spring insert
Info
B00058-10
Under no circumstances should screw
negative effect on the engine characteristic.
–
Check the O-ring in the locking cap.
–
Position the locking cap.
–
Mount and tighten the screws.
Guideline
Remaining screws, engine
–
Switch off all power consumers and switch off the engine.
–
Remove the seat. (
–
Disconnect the negative (minus) cable
–
Pull back the plus pole cover
tery.
–
Hang the rubber band
–
Lift the battery up.
500069-10
–
Place the battery in the battery holder.
Battery (YTX4L-BS) (
–
Reconnect the rubber band
–
Attach the plus cable and replace the plus pole cover
–
Attach the minus cable
–
Mount the seat. (
500069-11
and adjusting spring

engages in the angle lever.

be turned as this would have a

M5
p. 65)
of the battery.

and disconnect the positive (plus) cable of the bat-

out to the bottom.

p. 88)
.

.

p. 65)
62
and slide them into

6 Nm (4.4 lbf ft)
.
