Pro-Form Studio Bike Pro 22 User Manual page 12

12. Have a second person hold the Console
Mount (5) and the attached Console (6) near the
Handlebar (4).
Pull the indicated wire tie (G) until the Mount
Wire (91) is extending from the Console
Mount (5). Then, remove the wire tie.
Connect the Mount Wire (91) to the Handlebar
Wire (90) in the Handlebar (4). Tip: The wire
connectors should slide together easily and
snap into place with an audible click. If they
do not, turn one connector and try again.
13. Tip: Avoid pinching the Wires (90, 91). Have
the second person pull the console wires (F) but
not the connectors out of the Console Mount
(5) as you slide the Console Mount onto the
Handlebar (4).
You can attach the Console Mount (5) in either
the standard position or the extended position.
For the standard position, align the Console
Mount with the inner holes (H, I). For the
extended position, align the Console Mount with
the outer holes (I, J).
Tip: Avoid pinching the Wires (90, 91).
Attach the Console Mount (5) with two M6 Bolt
Sets (70).
See the inset drawing. Insert the console
wires (F) into the Console Mount (5). Then, slide
the Wire Protector (98) onto the console wires,
and press the Wire Protector into the Console
Mount.
12
G
4
90
13
Avoid pinching
the wires
70
91
90
4 I
H
12
6
5
91
F
5
70
J
F
98
5