Pro-Form Studio Bike Pro 22 User Manual page 10

8. See the inset drawing. Connect the Handlebar
Wire (90) to the Frame Wire (82). Tip: The wire
connectors should slide together easily and
snap into place with an audible click. If they
do not, turn one connector and try again.
Next, tighten the zip tie (C) around the indicated
mark (D) on the Handlebar Wire (90). Then, cut
off the excess zip tie.
9. Tip: Avoid pinching the wires. Press the Motor
Cover (38) onto the Frame (1), and attach it with
an M4 x 20mm Screw (80).
8
82
90
9
1
10
C
C
D
82
90
80
38
Avoid
pinching
the wires