Adding Sound To A Still Image - Sharp VE-CG40U Operation Manual

Adding Sound to a Still
Image
Available in w mode
You can add sound to a still image stored in the
card.
1
Set the Mode Dial to "w", then power
on camera.
2
Press j or k to select the image to
which you want to add sound.
3
Press the MENU button until the menu
screen appears.
4
Press l or m to select "w", then press
the SET button.
5
Press l or m to select "DUBBING",
then press the SET button.
6
Press l or m to select "ON", then press
the SET button.
DU B B I N G
7
Press the Shutter button fully to
begin dubbing.
VE-CG40U-033-040
P R E V I EW
P RO T E C T
I MAG E E F F E C T
S L I D E S HOW
P R I N T ORD E R
D E L E T E A L L
DU B B I N G
R E T URN O F F
ON
O F F
ON
39
8
Press the Shutter button fully to stop
dubbing.
• The maximum dubbing time is 10
seconds. After 10 seconds elapse, the
dubbing stops automatically even if you
do not press the Shutter button.
Notes:
• If you dub an image that already has sound,
the new sound overwrites the old.
• If you want to overwrite the sound on a protected
image, cancel the protection first.
• See page 40 to playback an image with sound.
02.8.27, 7:32 PM
39