Warning Indicators - Sharp VE-CG40U Operation Manual

Operation References

Warning Indicators

If a warning indicator appears on the screen, follow the specified instructions.
Warning indicators
NO C ARD
NO IMAGE S
CARD I S FUL L
CARD SLOT COVER
I S
OPEN
L ENS ERROR
TURN POWER
OF F ON AGA I N /
MAX. IMAGE NO.
CARD I S S E T
RE AD ONL Y
PROC E SS I NG WAS
S TOPPED
CANNOT RE AD
THE I MAGE DA T A
BAT TE RY I S TOO LOW
TO TRANSF E R THE DA T A
P R I NT SE T T I NG
TO 9 9 9 IMAGE S
D I SCONNE C T E D
4
VE-CG40U-001-006
The card is not inserted or is inserted improperly. Check
that it is properly inserted (see page 9).
The card has no images recorded in the format the camera
can recognize.
The capacity of the card is full and cannot store any more
images. Delete unnecessary images (see page 19) or
replace the card with a new one (see page 9).
The card slot cover is open. Close the cover.
If you power on the camera in any of the capture modes
and the lens barrel is obstructed (e.g. by a hand, flat
surface, lens cap), it may freeze after making contact three
times. In such case, turn the power off, remove the
obstruction then power on again.
You cannot record any image with a file number bigger
than 999-9999. Format the card or replace it with a new
one.
TO
The card is write-protected (see pages 9, 60).
The camera failed to process the data. Make sure the
operation procedure is correct.
The selected image cannot be read by this camera.
Replace the batteries with new AA alkaline batteries or fully
charged Ni-MH rechargeable batteries (commercially
available) (see page 7).
I S UP
You cannot set the print order to more than 999 images.
Improper connection. Check the USB connection and
make sure the card is firmly inserted in its slot (see page 9,
57).
4
Description of warning
02.8.27, 7:16 PM