Toro Multi Pro 5800-D Operator's Manual page 86

4. Prepare rust inhibiting, non-alcohol based,
RV antifreeze solution; refer to
Conditioner (page
5. Remove the tube from the back of the pressure
gauge and place the end of the tube into a
container (Figure
Figure 122
1. Pressure-gauge tube
2. Tube coupler
6. Start the engine and lower the outer booms
sections.
Conditioning the Sprayer
1. Run the spray pump for a few minutes to
circulate the RV antifreeze throughout the spray
system and any installed spray accessories.
2. Turn the left, center, and right section switches
to the O position.
N
3. Turn the master section switch to the O
and look for the following:
•
Ensure that RV anti-freeze flows from the
disconnected end of the pressure-gauge
tube.
•
Spray out the nozzle until the RV anti-freeze
is visible.
Preparing the
43).
122).
3. Pressure gauge
N
4. Turn the master section switch to the O
position.
5. Turn the pump switch to the O
6. Use the boom-section lift switches to raise the
outer boom sections.
Raise the boom sections until they have moved
completely into boom-transport cradle forming
the "X" transport position and the lift cylinders
are fully retracted.
Note:
retracted to prevent actuator rod damage.
7. Shut off the engine.
8. Drain the sprayer tank as completely as
possible.
Long-Term Storage
(Longer than 30 days)
Perform the following procedures found in
Storage (page
1. Cleaning the Exterior of the Machine (page 85)
2. Preparing to Condition the Sprayer (page 85)
3. Conditioning the Sprayer (page 86)
In addition, perform the procedures that follow:
1. Servicing the Chassis (page 86)
2. Service the Sprayer (page 86)
3. Servicing the Engine (page 87)
4. Servicing the Fuel System (page 87)
g276304
5. Servicing the Battery (page 87)
6. Protecting the Machine (page 87)
Servicing the Chassis
1. Check the air pressure in the tires; refer to
Checking the Tire Air Pressure (page
2. Check the brakes; refer to
(page
3. Check and tighten all bolts, nuts, and screws.
Note:
or damaged.
4. Paint all scratched or bare metal surfaces
(paint is available from your authorized Toro
distributor).
position
Service the Sprayer
1. Clean the agitation valve and the 3 section
valves; refer to
Section Valves (page
2. Grease the sprayer; refer to
Pump (page
86
Make sure that the lift cylinders are fully
85):
Adjusting the Brakes
70).
Repair or replace any parts that are worn
Cleaning the Agitation and
78).
53).
FF
position.
FF
Short-Term
24).
Greasing the Spray