KYMCO YUP 250 Manual page 68

5. ENGINE REMOVAL/INSTALLATION
Remove three screws, then remove rear fender
C.
Remove the right rear shock absorber lower
bolt, rear axle nut, collar and two rear fork
bolt.
Remove the rear fork.
Disconnect two water hoses from water
ducts.
Disconnect oil pressure switch lead.
Disconnect secondary air vacuum tube and
fuel pump vacuum tube from intake manifold.
Disconnect secondary air cleaner fresh air
outlet hose from secondary air cleaner.
Disconnect thermo unit wire and radiator air
ventilated tube from thermostat.
5-5
www.PlanDeGraissage.org
Rear Fender C
Screw
Right Rear Shock Absorber Lower Bolt
Rear Axle Nut
Water Hose Oil Pressure Switch Lead
Thermo
Fuel Pump
Unit Wire
Vacuum Tube
Secondary Air Cleaner
Fresh Air Outlet Hose
YUP 250
Screws
Rear Fork Bolts
Radiator Air
Ventilated Tube
Secondary Air
Vacuum Tube