Car Mode - Dog trace DOG GPS X20+ Manual

Setting the sensitivity – :
Setting the sensitivity for modes 0, 1, 2, 5, 6 serves for more precise recognition
between moving/stationary dog.
S-1: Lower sensitivity – the dog is considered stationary even when it is moving al little
bit.
S-9: High sensitivity – the dog is considered stationary only if it is absolutely still.
Setting of sensitivity in mode 3, 4 serves to set the radius of the virtual circle.
If the dog moves within this circle for certain time (t), the receiver will conclude the
dog has found a wild boar.
Sensitivity - S
Radius - r [m]
The set radius of the virtual circle is approximate only – we need to respect the
imprecision of the GPS position location.
Setting of the time – :
Setting of time for modes 0, 1, 2, 5, 6 – the indication will begin if the dog remains in
a given condition (moving/still) for a set time period. A delay in the status indication
also depends from the set interval of location updates (see chapter 6.4 on page 28).
interval of
updates [s]
time t 1
indication
7
delay [s]
The times in the table are estimates only.
Setting of time for modes 3, 4 – the indication will start, if the dog remains in the
virtual circle for time period t.
Setting the volume of audio indications – :
Audio indication can be adjusted in 3 levels. The set volume will affect the other
functions too - FENCE.

8.6 CAR mode

Vehicle body and electronics can affect the function of the digital compass in the
receiver - the direction of the dog being watched may not be displayed correctly. When
CAR mode is activated, the direction to the dog will not be determined from the digital
compass, but from changing the position of the GPS receiver.
Turning the CAR mode on and off:
1. Push the and the BEEPER button simultaneously for 2 seconds.
2. A message
1 2
5 10
3
2 3 4
10 13 16
time t
Indication delay [s]
will be shown on the display.
3 4 5
20 30 35
6
1 2 3 4
10 16 22 28
1 2 3
30 60 90
6 7 8
40 45 50
9
1 2 3
11 20 29
4
120
9
60
4
38
35