Future light DJ-HEAD 575 WASH Pro-Head-Wash User Manual page 43

- PAN/TILT-Feedback:
This function allows to return the Mowing Head to the required position after changing the position by
external force (e. g. by stroke). Use the [Up] and [Down] keys to select "On" if you wish to enable this
function or "Off" if you wish not to return the Moving Head to the required position and press [Enter] to
confirm or [Mode] to cancel and return to the menu.
Note: If feedback was switched Off, the PAN/TILT-position is changed by external force and feedbeck is
switched On again, the Moving Head might not to be synchronized with the DMX signal. You have to make a
reset in order to synchronize the Moving Head with the DMX signal.
- Lamp off via DMX
This function allows you to switch off the lamp by DMX. Use the [Up] and [Down] keys to select "On" if you
want to switch off the lamp by DMX or "Off" if you don't want to switch off the lamp by DMX and press
[Enter] to confirm or [Mode] to cancel and return to the menu.
- Temperature
Inside temperature readouts of the fixture in Celsius. Inside temperatures below 80° C are not critical. 80° C
and more lead to the lamp being switched off. Please note that the outside temperature should not exceed
45° C.
- Fan speed operating
By using this function you can choose 5 types of fan speed operating. Browse through this menu by the
pressing [Up] and [Down] keys - the display shows step by step the following messages: "Auto, HIGH, reG,
Lo.HI, Lo.OF". Press [Enter] if you wish to select one of them or [Mode] to cancel and return to the menu.
- continuous controlling of the fan speed without the DMX value
This mode is similar to "reG", but the initial level of the fan speed can´t be adjusted by DMX.
- high speed of the fans
The cooling fans work on max. speed (max. cooling).
- continuous controlling of the fan speed
The fan automatically raises its speed in order to control inside temperature of the lighting, if the
temperature inside increases about certain level (the low fan speed reduces the cooling of the
lighting). This cycle can repeat several times until the temperature inside is on a suitable level.
- low speed / switch off the lamp operating
The fan keeps the adjusted low speed until the temperature exceeds max. inside temp. then the
DJ-HEAD 575 WASH automatically switches off the lamp.
- low/high speed of the fan operating
The fan keeps the adjusted low speed until the temperature exceeds max. inside temp. of the
fixture, then the DJ-HEAD 575 WASH automatically switches from low to high fan-speed.
Note: In the mode "HIGH" and "Auto"- the fan speed can´t be adjusted by DMX.
43/92 00025955.DOC, Version 1.2