Set Detection Scenes And Tracking; Set Rules - HIKVISION DS-2TD4238-7/S2 User Manual

Thermal & Optical Bi-spectrum PTZ Network Camera User Manual

5.3.1 Set Detection Scenes and Tracking

Multiple detection scenes are supported for both channels. You can create scenes and set the
tracking parameters for better target monitoring performance.
Steps
1. Go to Configuration → VCA , and select a camera channel.
2. Click Scene Configuration and New Scene to create one or more scenes.
3. Select a numbered scene from the navigation bar on the left and enter a Scene Name.
Note
If you want to show the name on the image, check Display Scene Name.
4. Select the type of the scene.
Note
The configured rules in current scene will be cleared if you modify the type.
5. Check Track to enable the target tracking function for the scene.
6. Optional: Check Limited Tracking and set the auto tracking range.
The camera channel tracks a target only within the set auto tracking range.
1) Control the PTZ buttons to a desired scene and click Set Up Limit to save the position as the
scene's upper boundary.
2) Repeat to set the left, right and lower boundaries of the scene.
7. Set other tracking parameters.
Tracking Duration
Set the duration of tracking. If the value is selected as 0, the tracking duration will not be
limited.
Zooming Ratio
It is the zoomed-in level when the camera channel is tracking a target.
Go to Configuration → VCA → Zooming Ratio , select a scene from the drop-down list, and
control the zoom in/out buttons to get a desired zooming level, and save the settings.
Post-tracking
Set the duration of automatic tracking of the target after it stops.
Go to Configuration → VCA → Advanced Configuration , and set parameter.
8. Click Save.

5.3.2 Set Rules

The device can detect whether there is any target breaking the VCA rules. The optical camera will
track the target or the device will alarm when the VCA rule is triggered.
25