Advertisement
S T E P
3
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware first in this step. Wrench tighten ALL hardware at the end of
STEP 3A. Some components may be pre-assembled. Nylon lock nuts will not fully screw
onto bolts, they must be wrench tighten to fully go on.
3A. Disassemble and re-attach the Rear Top Frame (G) from the Main
Rack to Rear Uprights (B) using:
4 - (#1) M16x105mm Hex Head Bolt
8 - (#3) M16 Flat Washer
4 - (#4) M16 Nylon Lock Nut
12
Advertisement
