Advertisement
S T E P
2
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step. DO NOT wrench tighten until instructed.
Some components may be pre-assembled. Nylon lock nuts will not fully screw onto
bolts, they must be wrench tighten to fully go on.
2A. Attach Top Side Frames (C) to the Uprights of the Main Frame (F)
using:
4 - (#2) M16x110mm Hex Head Bolt
8 - (#3) M16 Flat Washer
4 - (#4) M16 Nylon Lock Nut
2B. Attach Top Side Frames (C) to the Rear Uprights (B) using:
4 - (#1) M16x105mm Hex Head Bolt
8 - (#3) M16 Flat Washer
4 - (#4) M16 Nylon Lock Nut
10
Advertisement
