Table of Contents
Advertisement
RADIANQBIO INSTRUMENT
3) RI-25W
At the time of purchasing sensor, the rated capacity (displacement) and rated output
(R.O) declared on the calibration sheet can be used for the calibration for easier
calibration.
DP-xx series (Half type (HBT) recommends setting the rated output value to
approximately 0.3300.
Refer to 8-5.Actual load calibration if you need to correct the error.
Measuring mode
While
key is being Press, press
※ Zero position will change after setup is complete.
※
Measuring Mode
key
Display Function mode
Display Sensor output value calibration mode
Display output type select mode
Select the sensor output type by using
And then. Press
Display R.C. value(Rated capacity) input mode
Input the rated capacity value by using
And then. Press
Calibration end
: The state in which the current measurement is being displayed
key
key
33
www.radian21.com
and
key.
and
key.
Advertisement
Table of Contents
