Maytag MLE24PDAYW Installation Instructions Manual page 12

Power Supply Cord,
Three-wire electrical connection
This blade connected to
this conductor.
D
E
A. Spade terminals with upturned ends
B. Ring terminals
C. Neutral (white or center)
D. 3/4" (19 mm) UL-listed strain relief
E. Neutral
Three-wire power supply cord must
have three, No. 10 copper wires and
match a three-wire receptacle of
NEMA Type 10-30R.
12 12
Use this method where local codes permit
connecting neutral ground wire to neutral wire:
:
5. Loosen or remove the center terminal
6. Connect the neutral wire (white or center)
7. Connect the other wires to outer terminal
A
8. Tighten strain relief screws.
9. Insert tab of the terminal block cover into
B
C
Use this method where local codes do not permit
connecting neutral ground wire to neutral wire:
5. Remove the center terminal block screw.
6. Remove the appliance neutral ground
7. Connect the other wires to outer terminal
8. Tighten strain relief screws.
9. Insert tab of the terminal block cover into
10. After reattaching the terminal cover,
If codes permit and a separate ground wire
is used, it is recommended that a qualified
electrician determine that the ground path
is adequate.
block screw.
of the power supply cord to the center
terminal screw of the terminal block.
Tighten screw.
block screws. Tighten screws.
slot of the dryer rear panel. Secure cover
with hold-down screw.
wire from the external ground conductor
screw. Connect the appliance neutral
ground wire and the neutral wire (white or
center) of the power supply cord under
the center terminal block screw. Tighten
screw.
block screws. Tighten screws.
slot of the dryer rear panel. Secure cover
with hold-down screw.
connect a separate copper ground wire
from the external ground conductor screw
to an adequate ground.
A
F
E
D
A. External ground conductor screw
B. Center terminal block screw
C. Outer terminal block screws
D. Strain relief screw
E. Neutral (center wire)
F. Appliance neutral ground wire
A
C
B
G
F
A. Separate copper ground wire
B. External ground conductor screw
C. Appliance neutral ground wire
D. Center terminal block screw
E. Outer terminal block screws
F. Strain relief screw
G. Neutral (center wire)
B
C
D
E