Baxi Solo 2 PF Installation And Servicing Instruction page 22

5.0 Installation – Page 22
5.11 Method A (Cont)
7. Engage the assembly into the hole previously cut in
the wall and slide into place.
8. Secure the assembly to the wall at the previously
drilled anchorage points with suitable screws. Before
finally tightening the screws, check that the assembly is
level (Fig. 51).
9. Make good between the wall and the air duct inside
and outside the building if the internal fitting kit has not
been used (Fig. 52).
10. The flue trim provided may be fitted, if required, to
neaten up the make-up around the terminal. This plate
may also be used as a protection plate on outside walls of
combustible material.
11. Fit the trim over the flue terminal and mark through
the four securing holes. Remove the trim, drill holes
63mm (2 ½ in) deep to accept suitable wall plugs. Fit the
trim over the flue terminal and secure using suitable
screws (Fig. 53).
22