Planet Networking & Communication SGS-5220 User Manual page 35

10Gbps SFP+ (10G Ethernet/10GBASE)
Model
Speed (Mbps)
MTB-SR
MTB-LR
10Gbps SFP+ (10GBASE-BX, Single Fiber Bi-directional SFP)
Model Speed (Mbps)
MTB-LA20 10G
MTB-LB20
10G
MTB-LA40 10G
MTB-LB40
10G
MTB-LA60 10G
MTB-LB60
10G
1. It is recommended to use PLANET SFP on the Managed Switch. If you insert an SFP transceiver
that is not supported, the Managed Switch will not recognize it.
2. Port 25 to Port 26 are a shared SFP+ slot that supports the 10 Gigabit SFP+ transceiver and
Gigabit SFP transceiver.
1. Before we connect the switch to the other network device, we have to make sure both sides of the SFP transceivers are
with the same media type, for example: 1000BASE-SX to 1000BASE-SX, 1000BASE-LX to 1000BASE-LX.
2. Check whether the fiber-optic cable type matches with the SFP transceiver requirement.

To connect to 1000BASE-SX SFP transceiver, please use the multi-mode fiber cable with one side being the male
duplex LC connector type.

To connect to 1000BASE-LX SFP transceiver, please use the single-mode fiber cable with one side being the male
duplex LC connector type.

Connect the Fiber Cable
1. Insert the duplex LC connector into the SFP/SFP+ transceiver.
2. Connect the other end of the cable to a device with SFP/SFP+ transceiver installed.
3. Check the LNK/ACT LED of the SFP/SFP+ slot on the front of the Managed Switch. Ensure that the SFP/SFP+
transceiver is operating correctly.
4. Check the Link mode of the SFP/SFP+ port if the link fails. To function with some fiber-NICs or Media Converters, user
has to set the port Link mode to "10GForce", "1000 Force" or "100 Force".

Remove the Transceiver Module
1. Make sure there is no network activity anymore.
2. Remove the Fiber-Optic Cable gently.
Connector
Interface
10G LC
10G LC
Connector
Fiber Mode
Interface
WDM(LC) Single Mode
WDM(LC) Single Mode
WDM(LC) Single Mode
WDM(LC) Single Mode
WDM(LC) Single Mode
WDM(LC) Single Mode
User's Manual of SGS-5220 Series
Fiber Mode Distance
Multi Mode Up to 300m
Single Mode 10km
Distance Wavelength (TX) Wavelength (RX) Operating Temp.
20km 1270nm
20km 1330nm
40km 1270nm
40km 1330nm
60km 1270nm
60km 1330nm
35
Wavelength (nm) Operating Temp.
850nm 0 ~ 60 degrees C
1310nm 0 ~ 60 degrees C
1330nm 0 ~ 60 degrees C
1270nm 0 ~ 60 degrees C
1330nm 0 ~ 60 degrees C
1270nm 0 ~ 60 degrees C
1330nm 0 ~ 60 degrees C
1270nm 0 ~ 60 degrees C