How To Use The Operation Panel; Names And Functions Of The Respective Sections - JUKI IT-100D Instruction Manual

6. HoW To uSE THE oPErATIoN PANEL

6-1. Names and functions of the respective sections

1 4
2
3
1 Re-sewng swtch
2 Teachng swtch
3 Needle up/down compensatng swtch
4 Screen changeover swtch
5 Wth/wthout reverse feed sttch at sewng start swtch
6 Wth/wthout reverse feed sttch at sewng end swtch
7 Materal edge sensor swtch
8 One-shot automatc sewng swtch
9 Wth/wthout automatc thread trmmer swtch
Switch
Re-sewng swtch
1
Teachng swtch
2
Needle up/down compen-
satng swtch
3
Screen changeover swtch
4
Wth/wthout reverse feed
sttch at sewng start swtch
5
!7
5
6
!7
Ths swtch s used to contnue sewng from the step on the
way after replacng bobbn thread when bobbn thread has
run out durng program sttchng step.
Ths s the swtch to set the settng of the number of sttches
wth the value of number of sttches whch has been actu-
ally sewn.
Ths s the swtch to perform needle up/down compensatng
sttchng. (Needle up/down compensatng sttchng and one
sttch compensatng sttchng can be changed over wth functon
settng No. 22.)
Ths s the swtch to change over the screen.
Ths s the swtch to turn ON/OFF automatc reverse feed
sttch at sewng start.
* Ths swtch cannot be used wth the sewng machne
whch s not provded wth automatc reverse feed sttch-
ng devce.
– 18 –
8 7
!8
!0 !3
9
!0 Thread trmmng prohbtng swtch
!1 Backlght swtch
!2 Reset swtch
!3 Informaton swtch
!4 + swtch
!5 – swtch
!6 Counter/speed changeover swtch
!7 General-purpose swtch
!8 Power dsplay lamp
Description
!1 !2 !4 !5
!6