Custom Pattern; Custom Pattern SettNg - JUKI IT-100D Instruction Manual

■ One-shot automatic stitching
One-shot automatc sttchng can be set by each step.
1) In the programmed sttchng edt screen, press one-shot automatc sttchng swtch 5 to select the one-
shot automatc sttchng. (When t s n the selected state, a mark s dsplayed on the sde of swtch 5 .)
2) In the step where the one-shot automatc sttchng has been selected, the sewng machne wll automat-
cally contnue sewng, once the sewng machne starts runnng, untl the number of sttches of the step s
reached.
■ Teaching
Teachng can nput the number of sttches of nputtng step wth the number of sttches whch has been actu-
ally sewn.
1) Press swtch n the programmed sttchng edt screen and the teachng mode s selected.
2) Depress the front part of the pedal to sew untl the last sttch of the step s reached.
* At ths tme, nput of number of sttches cannot be performed by turnng handwheel by hand or usng
needle up/down compensatng swtch.
3) Stop the sewng machne wth the pedal n the neutral poston and the number of sttches whch has been
sewn s dsplayed on 2 .
1 : Set the step wth "+".
2 : Number of sttches whch has been sewn can be corrected by hand wth "+" and "–".
4) Make the step of 1 proceed to the subsequent step or make the sewng machne perform thread trm-
mng. Then the nput of the number of sttches for the step s completed.
■ Teaching screen

6-9. Custom pattern

Standard delivery level of the key lock is "1". When the level of the key lock is the case other
than "0", be sure to change the level to "0" to perform the operation below.
Free needle entry position can be specified and optional zigzag pattern can be created.
As many as 20 patterns can be created and as many as 500 sttches of each pattern can be nputted.
(1) Custom pattern setting
■ Sewing shape list screen
q w
w
q
– 50 –
1) Press swtch 1 of
n the sewng shape lst
screen.