CondensatOn Custom EdT - JUKI IT-100D Instruction Manual

(2) Condensation custom edit
■ Condensation custom edit screen
1) Press to dsplay the reverse feed sttchng settng screen.
2) Press 2 or 4
screen.
3) Set the needle entry poston for each step n the condensaton custom edt screen.
1 : Set the step wth "+" and "–" key.
2 : Set the value of needle entry pont from the center of zgzag wth "+" and "–". "+" value comes on the
rght sde and "–" value on the left sde.
3 : Needle entry poston s dsplayed.
4 : Insert needle entry pont 0. 0 for one sttch to the exstng step. Then the sttches move backward
one sttch by one sttch.
* It s not possble to nsert t when the number of total sttches s 64 sttches.
5 : Delete one sttch of the needle entry of the exstng step. Then the sttches move forward one sttch
by one sttch.
* It s not possble to delete t when the number of total sttches s "1" sttch.
4) When settng up to the last step s completed, proceed to the next step, press
mark .
* When the last step s 64, t s not necessary to set "END" mark
5) When all nputtng procedures have been completed, press
■ The second screen of reverse feed stitching setting
Example) Condensation custom at sewing start Width 4 mm for 2-step zigzag stitch
1st
Needle
entry sttch
Input
– 2.0
value
1 Input the data of the lst n the condensaton custom edt screen.
2 Set 4 mm at 1 n the 2nd screen of reverse feed sttchng settng. When 1 s changed, the nputted
needle entry can be ncreased/decreased.
q w e
q w r t
n the reverse feed sttchng settng screen to move to the condensaton custom edt
q
2nd 3rd 4th
sttch sttch sttch
– 0.7 0.6 2.0
y
.
key to determne.
5th 6th 7th
sttch sttch sttch
0.6 – 0.7 – 2.0
– 55 –
6 and put END
8th 9th
10th 11th
sttch sttch
sttch sttch
– 0.7 0.6
2.0 END