All JF1 wires have been bundled into single keyed ribbon cable to simplify the
connection. The red wire in the ribbon cable plugs into pin 1 of JF1. Connect the
other end of the cable to the Control Panel printed circuit board, located just behind
the system status LEDs in the chassis. Note: NC indicates no connection.
Figure 5-2. Front Control Panel Header Pins (JF1)
5-5
I/O Ports
The I/O ports are color coded in conformance with the PC 99 specifi cation. See
Figure 5-3 below for the colors and locations of the various I/O ports.
Chapter 5: Advanced Serverboard Setup
20
19
NC
x (key)
Power LED
HDD LED
NIC1
NIC2
OH/Fan Fail LED
Power Fail LED
Ground
Ground
2
1
Figure 5-3. Rear Panel I/O Ports
5-7
NC
x (key)
Vcc
Vcc
Vcc
Vcc
Vcc
Vcc
Reset Button
Power Button