Supermicro AS-1040C-8 User Manual page 84

AS1040C-T/1040C-8 User's Manual
Hyper Transport Confi guration
CPU0: CPU1 HT Link Speed
The HT link will run at the speed specifi ed in this setting if it is slower than or equal
to the system clock and if the board is capable. Options are Auto, 200 MHz, 400
MHz, 600 MHz, 800 MHz and 1 GHz.
CPU0: CPU1 HT Link Width
The HT link will run at the width specifi ed in this setting. Options are Auto, 2 bit,
4 bit, 8 bit and 16 bit.
CPU0: PCI-X0 HT Link Speed
The HT link will run at the speed specifi ed in this setting if it is slower than or equal
to the system clock and if the board is capable. Options are Auto, 200 MHz, 400
MHz, 600 MHz, 800 MHz and 1 GHz.
CPU0: PCI-X0 HT Link Width
The HT link will run at the width specifi ed in this setting. Options are Auto, 2 bit,
4 bit, 8 bit and 16 bit.
CPU: HT_Slot HT1 Link Speed
This setting becomes accessible when a card is installed to the J34 HT slot. The
HT link will run at the speed specifi ed in this setting if it is slower than or equal to
the system clock and if the board is capable. Options are Auto, 200 MHz, 400
MHz, 600 MHz, 800 MHz and 1 GHz.
CPU: HT_Slot HT1 Link Width
This setting becomes accessible when a card is installed to the J34 HT slot.The
HT link will run at the width specifi ed in this setting. Options are Auto, 2 bit, 4 bit,
8 bit and 16 bit.
MPS Confi guration
MPS Revision
This setting allows the user to select the MPS revision level. The options are 1.1
and 1.4.
7-12