Table of Contents
Advertisement
Wake-On-LAN
The Wake-On-LAN header is desig-
nated JWOL. See the table on the
right for pin defi nitions. You must
have a LAN card with a Wake-On-LAN
connector and cable to use the Wake-
On-LAN feature.
Wake-On-Ring
The Wake-On-Ring header is desig-
nated JWOR. This function allows
your computer to receive and "wake-
up" by an incoming call to the modem
when in suspend state. See the table
on the right for pin defi nitions. You
must have a Wake-On-Ring card and
cable to use this feature.
Overheat LED
Connect an LED to the JOH header to
provide warning of chassis overheat-
ing. See the table on the right for pin
defi nitions.
3rd Power Supply Alarm
Reset Header
Connect a cable from your power
supply to JAR to provide you with
warning of a power supply failure.
The warning signal is passed through
the PWR_LED pin to indicate a power
failure. See the table on the right for
pin defi nitions.
Chapter 5: Advanced Serverboard Setup
Wake-On-LAN
Pin Defi nitions
Pin#
1
2
3
Wake-On-Ring
Pin Defi nitions
Pin#
1
2
Overheat LED
Pin Defi nitions (JOH)
Pin#
1
2
3rd Power Supply
Alarm Reset Header
Pin Defi nitions (JAR)
Pin#
Defi nition
1
P/S 1 Fail Signal
2
P/S 2 Fail Signal
3
P/S 3 Fail Signal
4
Reset (from MB)
Note: This feature is only available when using
redundant power supplies.
5-17
(JWOL)
Defi nition
+5V Standby
Ground
Wake-up
(JWOR)
Defi nition
Ground (Black)
Wake-up
Defi nition
+3.3V
OH Active
Advertisement
Table of Contents
