Printing A List Of Selected Options(Led) - Fujitsu DL7600Pro User Manual

PRINTING A LIST OF
SELECTED
OPTIONS(LED)
<< FUNCTION >>
SAVE&END MENU1
HEX-DUMP V-ALMNT
User's Manual
The LIST function prints a list of all the printer's currently selected
options. This function is useful for checking the printer settings when
you first enter setup mode or just before you exit. To print a list of
options, load continuous forms paper and then proceed as follows:
1. Enter setup mode.
Press the SETUP button until the printer beeps. Wait for the
printer to stop printing and check that the following
<<FUNCTION>> menu is printed:
MENU2 HARDWRE ADJUST
INITIAL
2. Select the LIST function.
Repeatedly press the "TEAR OFF" or "LOAD" button to
position the cursor on the left edge of the aluminum print guide
on LIST. Next press the  button or the  button to select the
LIST function. The printer starts to print a list of the currently
selected options. The preselected factory settings, also called
factory defaults, are shown on the opposite page.
When the printer finishes printing the list of options, it reprints
the <<FUNCTION>> menu.
3. Do either of the following:
•
•
For details about other functions, see the other sections in this
chapter. To exit setup mode and save your changes, make sure
that the cursor on the left edge of the aluminum print guide is
positioned on SAVE & END, then press the  button or the 
button.
CONFIG GAP-ADJ
Select another function, or
Exit setup mode, saving any changes you made.
USING SETUP MODE
DEFAULT LIST SELF-TST
5-11